Aid and Trade

Wholesale Price:     $111.98

Designed for wlan applications operating in the 2.4- To 2.5-Ghz frequency range, the antenna has a nominal gain of 5.2 Dbi. The antenna is used primarily with access points, but is compatible with cisco aironet radio products utilizing a reverse-polarity threaded neil concelman (rp-tnc) connector. The location of the antenna is important. Objects such as metal columns, walls, etc. Will reduce efficiency. Best performance is achieved when transmit and receive antennas are mounted at the same height and in a direct line of sight with no obstructions. If this is not possible and reception is poor, you should try different mounting positions to optimize reception. The antenna is designed to attach to and hang from a standard suspended ceiling track having a width from 13/16 inches (20.6 Millimeters) to 1 1/4 inches (31.7 Millimeters). Features and specifications: antenna type: dipole. Operating frequency range: 2.4- To 2.83-Ghz. Vswr: less than 2:1, 1.5:1 Nominal. Gain: 5.2 Dbi. Polarization: vertical. E-plane (3db bandwidth): 50 degrees. H-plane (3db bandwidth): omnidirectional. Cable length and type: 3 ft (0.91 M). Plenum rated rg-58. Dimensions (h x w): 9 in. X 1.25 In.(22.8 Cm x 3.2 Cm). System requirements: this antenna is designed for use with cisco aironet access points, but can be used with any 2.4-Ghz cisco aironet radio device that utilizes a rp-tnc connector. Installation notes: choosing a mounting location: the location of the antenna is important. Objects such as metal columns, walls, etc. Will reduce efficiency. Best performance is achieved when transmit and receive antennas are mounted at the same height and in a direct line of sight with no obstructions. If this is not possible and reception is poor, you should try different mounting positions to optimize reception. The antenna is designed to attach to and hang from a standard suspended ceiling track having a width from 13/16 inches (20.6 Millimeters) to 1 1/4 inches (31.7 Millimeters). Tools and equipment required: to install the antenna on a suspended ceiling track, you will need the following tools and equipment. A ceiling track bracket (shipped with your antenna). A 7/16 inch (11.1 Millimeters) wrench. Cable ties or electrical tape.